The loading gantry is to push and release the heating blank, and the table top has a slope of 3 °. When working, the crane can hang the whole bundle onto the gantry and arrange them in order. The heated billet will be next to the end that is automatically rolled to the gantry. The end has a feeding positioning seat. Due to the large difference in the diameter of the workpiece, the material positioning seat can be adjusted according to the diameter of the workpiece. This loading gantry is designed according to the user's working characteristics and has a successful experience. Labor-saving, convenient, simple, reliable and practical. Other methods are also available, but the cost is high. For example, when the stepping device is loaded, at the beginning, the blanks must be hung one by one to the positioning position of the walking beam blank, and the pendulum is placed at the rear end of the stepping device. Place one material positioning point, each one is taken away, and then another material is placed on the positioning point. Work is very busy.