At present, in the production of automobile stabilizer bars, high-temperature fuel furnaces are used to heat the stabilizer bars, and the stabilizer bars are placed in the furnace for centralized heating, and the preheating, heating and heat preservation processes are required. The heating time is long and the speed is slow. Due to the large size of the fuel furnace, A large amount of energy is wasted every time it is burned, which also increases the production cost of the stabilizer bar.
It includes a bracket. The bracket is equipped with several intermediate frequency heating furnace bodies. The intermediate frequency heating furnace body has a workpiece inlet on the side. The intermediate frequency furnace body has a furnace ring made of hollow copper tubes. The bracket is equipped with a water inlet main pipe and a drain main pipe. There are several water inlet pipes and drain pipes on the circle. Both the water inlet pipes and the drain pipes protrude from the intermediate frequency furnace body, in which the water inlet pipes and the water inlet main pipe are connected, and the drain pipes and the drain main pipe are connected. There is a cylinder, the end of the cylinder rod is fixed with a continuous wrench, a bracket is fixed on the bracket, a guide roller is installed on the bracket, and a far infrared detector is also installed on the bracket. The advantage is that when using, the work stabilizer bar is hooked on the continuous wrench, and the work stabilizer bar is placed on the guide roller, the cylinder works, and the work stabilizer bar is continuously fed into the intermediate frequency heating furnace body for heating. After heating, the cylinder 1 In this way, the stabilizing rod of the work piece is taken out of the intermediate frequency heating furnace body continuously ; the device can heat a single stabilizing rod, the heating time is short, the speed is fast, the structure is simple, energy is saved, and the production cost of the stabilizing rod is reduced.
BRIEF DESCRIPTION:
Fig. 1 is a structural schematic diagram of the present invention, and 2 in the figure is a workpiece stabilizer bar.
FIG 2 is a side view of the present invention novel.
Intermediate frequency heating furnace for automobile stabilizer bar heating. It includes a bracket 3 , which is equipped with a number of intermediate frequency furnace bodies 1 , a work inlet on the side of the intermediate frequency furnace body, a furnace ring 2 made of hollow copper tubes in the intermediate frequency furnace body , and a water inlet main pipe 5 and a drain main pipe 4 , There are several water inlet pipes and drain pipes on the furnace ring, the water inlet pipes and the drain pipes extend from the intermediate frequency furnace body l , in which the water inlet pipe and the water inlet main pipe 5 are connected, the drain pipe and the drainage main pipe 4 are connected, the intermediate frequency furnace body work piece A cylinder 6 is mounted on the bracket in front of the entrance , a spanner 7 is fixed on the end of the cylinder rod , a bracket 9 is fixed on the bracket , a guide roller 8 is mounted on the bracket, and a far infrared detector 10 is also mounted on the bracket .