1. When the thyristor device is tested for the withstand voltage, please remove the control board, otherwise the control board may be permanently damaged.

2. Internal circuits and parameters are subject to change without notice.

3. The company is not responsible for any damage to parts other than the control panel during use.

4, DLJ device is a kind of CMOS device, should pay attention to the use of the device, the short circuit between the two pins is strictly prohibited, otherwise the chip will be damaged, in order to ensure the security of the device, so avoid using the multimeter to directly measure the device pins.

For safety reasons, please refer to the following introduction

1，Induction heating furnace control board debugging precautions

2，Induction heating furnace control panel debugging principle

3，Tools for preparation of induction heating furnace control panel debugging

4，Induction heating furnace protection safety debugging process

5，The induction heating furnace debugging method is summarized, so that debugging is the safest!