1. intermediate frequency forging furnace Check whether the main control cabinet, transformer and sensor are connected to water before starting the machine. Also check the waterway for blockages. It is strictly forbidden to work in the absence of water.

2. Before closing the air, check whether the power button pops up (bumping is off). Before pressing the power button, ensure that the start button pops up (bounces off) and ensures that the power adjustment button is turned small.

3.  intermediate frequency forging furnaceCheck if the sensor is short-circuited before starting the machine. Never allow the machine to turn on when the sensor is shorted. No-load high-power start-up equipment is strictly prohibited.

4.  intermediate frequency forging furnaceAfter the sensor is placed in part of the workpiece at start-up, start the machine and slowly turn the power adjustment knob to the desired position.

5.  intermediate frequency forging furnaceWhen the machine is turned off and the workpiece is not less than half, turn the power adjustment knob to a small rotation. The shutdown sequence should be to first turn the power adjustment button to small, then bounce the start button (stop) and bounce the power button (off). It is strictly forbidden to turn off the power button directly under high power output.

6. After the equipment is turned off, the cooling water should continue to cool for more than 20 minutes to ensure that the equipment is completely cooled.

7. It is strictly forbidden to push out the hot material in the sensor when the power adjustment button is activated in the 7- to-large position (causing the machine to output high-power no-load).

8. Dedust the equipment inside for one month, and descale the equipment cooling system with detergent for 3 months. The descaling time can be shortened depending on the water quality.